IPv6 Questions

Question 1

Refer to the exhibit.

R1#show ipv6 route C 2001:DB8::/64 [0/0] via Ethernet0/0, directly connected L 2001:DB8::1/128 [0/0] via Ethernet0/0, receive

Which statement is true?

A. 2001:DB8::1/128 is a local host route, and it can be redistributed into a dynamic routing protocol.
B. 2001 :DB8::1/128 is a local host route, and it cannot be redistributed into a dynamic routing protocol.
C. 2001:DB8::1/128 is a local host route that was created because ipv6 unicast-routing is not enabled on this router.
D. 2001:DB8::1/128 is a route that was put in the IPv6 routing table because one of this router’s loopback interfaces has the IPv6 address 2001:DB8::1/128.

Answer: B

Question 2

Which three actions are required when configuring NAT-PT? (Choose three)

A. Enable NAT-PT globally.
B. Specify an IPv4-to-IPv6 translation.
C. Specify an IPv6-to-IPv4 translation.
D. Specify a ::/96 prefix that will map to an IPv4 address.
E. Specify a ::/48 prefix that will map to a MAC address.
F. Specify a :.732 prefix that will map to an IPv6 address.

Answer: B C D

Question 3

Which two features does the show ipv6 snooping features command show information about? (Choose two)

A. RA guard
B. DHCP guard
C. ND inspection
D. source guard

Answer: A C

Question 4

Refer to the exhibit.

Which statement is true?

A. There is no issue with forwarding IPv6 traffic from this router.
B. IPv6 traffic can be forwarded from this router, but only on Ethernet1/0.
C. IPv6 unicast routing is not enabled on this router.
D. Some IPv6 traffic will be blackholed from this router.

Answer: D

Question 5

Refer to the exhibit.

Which part of the joined group addresses list indicates that the interface has joined the EIGRP multicast group address?

A. FF02::1
B. FF02::1:FF00:200
C. FF02::A
D. FF02::2

Answer: C

• Tweet
• Share
• Share
• Share
• Share

Sign up here with your email