Here you will find answers to Miscellaneous Questions
Question 1
You replaced your Layer 3 switch, which is the default gateway of the end users. Many users cannot access anything now, including email, Internet, and other applications, although other users do not have any issues. All of the applications are hosted in an outsourced data center. In order to fix the problem, which one of these actions should you take?
A. Clear the MAC address table in the switch.
B. Clear the ARP cache in the switch:
C. Clear the ARP cache in the end devices.
D. Clear the ARP cache in the application servers.
A. Clear the MAC address table in the switch.
B. Clear the ARP cache in the switch:
C. Clear the ARP cache in the end devices.
D. Clear the ARP cache in the application servers.
Answer: C
Question 2
Refer to the exhibit. Look at the command output. What would be the most probable reason for this port-ID mismatch?
Switch 1#show cdp neighbors
Capability Codes: R – Router, T – Trans Bridge, B – Source Route Bridge, S – Switch, H – Host, I – IGMP, r – Repeater
Switch1#
Switch 2#show cdp neighbors
Capability Codes: R – Router, T – Trans Bridge, B – Source Route Bridge, S – Switch, H – Host, I – IGMP, r – Repeater
Switch2#
|
A. spanning-tree misconfiguration
B. speed mismatch configuration
C. cabling problem
D. configuration problem
B. speed mismatch configuration
C. cabling problem
D. configuration problem
Answer: C
Question 3
When troubleshooting a network, the output of the command show interfaces indicates a large number of runts. What is a runt?
A. the number of packets that are discarded because they exceed the maximum packet size of the medium
B. errors created when the CRC generated by the originating LAN station or far-end device does not match the checksum calculated from the data received.
C. the number of packets that are discarded because they are smaller than the minimum packet size of the medium
D. the number of received packets that were ignored by the interface because the interface hardware ran low on internal buffers
E. the number of times that the interface requested another interface within the router to slow down
B. errors created when the CRC generated by the originating LAN station or far-end device does not match the checksum calculated from the data received.
C. the number of packets that are discarded because they are smaller than the minimum packet size of the medium
D. the number of received packets that were ignored by the interface because the interface hardware ran low on internal buffers
E. the number of times that the interface requested another interface within the router to slow down
Answer: C
Explanation
A runt is a packet that fails to meet the minimum size standard (below 64 bytes for Ethernet packet). Network protocols such as Ethernet often require that packets be a minimum number of bytes in order to travel the network. Runts are often the result of packet collisions along a busy network or can result from faulty hardware that is forming the packets or from corrupted data being sent across the network.
Question 4
A network administrator has applied the NTP peer statement to a Cisco IOS router. Which additional function is simultaneously being used on this router?
A. static server
B. symmetric active mode
C. NTP broadcast client
D. static client
B. symmetric active mode
C. NTP broadcast client
D. static client
Answer: B
Question 5
NTP will allow you to establish which three relationships between two networking devices?
A. client
B. server
C. broadcast
D. anycast
B. server
C. broadcast
D. anycast
Answer: A B C
Question 6
Which command can be used to solve the problem caused by a router configured with multiple DHCP pools?
A. host
B. default-gateway
C. network
D. ip helper
B. default-gateway
C. network
D. ip helper
Answer: A
Sign up here with your email
ConversionConversion EmoticonEmoticon